https://doi.org/10.1007/s11356-022-20859-x
”
The numerical study is performed using the steps outlined in the flowchart in Fig. 1 for each simulation point. First, the geometry of the RPB unit is prepared. Then, a computational mesh was generated. For the prepared mesh, a domain was defined, and the properties of boundary conditions, domains and materials were determined. Some properties are described based on experimental results. The next stage of processing is the solution in which the CFD simulation results are calculated. If the calculations did not converge, it is returned to mesh preparation, if it does converge, the results are checked, and the visualization is prepared. In the last step, the obtained simulation results were compared with the experimental results and presented on common graphs. The individual stages of model preparation are described in more detail later in this article.
“