Energy performance

https://doi.org/10.1016/j.petlm.2016.11.002 “As mentioned previously, most studies have focused on reducing the regeneration energy as they stated that its reduction would greatly reduce the CO2 capture plant

https://doi.org/10.1016/j.petlm.2016.11.002 “This energy has not been extensively studied in laboratory scale which is currently a set back because some amine solvents with low regeneration energy

https://doi.org/10.1016/j.petlm.2016.11.002 ” Regeneration energy is mainly a combination of three parameters as seen in Eq. (21) [156].(21)Qreg=[Qdes]+[Qsen]+[Qvap]where; Qreg (GJ/tonne CO2) is the energy of regeneration, Qdes (GJ/tonne CO2) is

https://doi.org/10.1016/j.petlm.2016.11.002 “Heat of absorption has an influence in the energy of regeneration because it is believed to be equal to the heat of desorption [156]. Therefore,

https://doi.org/10.1016/j.ijggc.2018.10.008 ” Desorption curves of Fig. 4 were all obtained using an initial microwave power of 100 W to quickly heat the solution to the desired regeneration temperature

https://doi.org/10.3390/en12132504 “The desorption temperature is an important factor of solvent properties and operating conditions. Figure 10 and Figure 11 show the result of the energy performance with different

https://doi.org/10.3390/en12132504 “The concentration of CO2 in the flue gas varies, especially in different power plants which use different coal and operating equipment or different industrial senses.

https://doi.org/10.3390/en12132504 “The liquid:gas ratio is an important parameter for the absorption effect of the absorption process and the energy consumption required for the desorption process.

https://doi.org/10.3390/en12132504 “At this stage, considering all aspects, like energy consumption, price, stability, environment pollution, and so on, MEA may not be the best but the

https://doi.org/10.3390/en12132504 “With the development of CCS technologies, amine-based post-combustion technologies could approach a commercial-scale project first, which remains the preferred CO2 capture technology for the short